No Vlan; Commands In The Interface Configuration Mode - Siemens SCALANCE S615 Configuration Manual

Network structures
5.1 VLAN
5.1.2.11

no vlan

Description
With this command, you delete a VLAN on the device.
Requirement
You are in the Global Configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameter:
no vlan <vlan-id(2-4094)>
Parameter
vlan-id
The VLAN with number 1 cannot be deleted.
Result
The VLAN is deleted
Further notes
With the
You can display information about the VLAN with the
5.1.3

Commands in the interface configuration mode

This section describes commands that you can call up in the interface configuration mode.
Depending on the Interface selected, various command sets are available.
In the Global configuration mode, enter the
Commands relating to other topics that can be called in the interface configuration mode can
be found in the relevant sections.
● If you exit the Interface configuration mode with the
Global configuration mode.
● If you exit the Interface configuration mode with the
Privileged EXEC mode.
154
Description
Number of the addressed VLAN
command, you create a VLAN on the device.
vlan
Range of values / note
2 ... 4094
command.
show vlan
command to change to this mode.
interface
command, you return to the
exit
command, you return to the
end
SCALANCE S615 Command Line Interface
Configuration Manual, 06/2015, C79000-G8976-C406-02