Auth Psk - Siemens SCALANCE S615 Configuration Manual
Simatic net industrial ethernet security command line interface
Hide thumbs
Also See for SCALANCE S615:
- Getting started (44 pages) ,
- Manual (36 pages) ,
- Operating instructions manual (80 pages)
Table of Contents
Advertisement
Security and authentication
9.3 IPsec VPN
You display this setting and other information with the
command.
You show the available certificates with the
You show the configuration of the IPsec connection with the
command.
You remove the authentication with the
9.3.6.2
auth psk
Description
With this command you specify that a key will be used for authentication.
Requirement
You are in the IPSEC AUTHENTICATION configuration mode.
The command prompt is as follows:
cli(config-conn-auth)#
Syntax
Call up the command with the following parameters:
auth psk <string(255)>
The parameter has the following meaning:
Parameter
string
Result
The key is configured.
Further notes
You display this setting and other information with the
command.
You remove the authentication with the
380
Description
Value for the key
show ipsec conn-authentication
command.
show-idx
show ipsec connections
command.
no auth
Range of values / note
Specify a valid key.
show ipsec conn-authentication
command.
no auth
SCALANCE S615 Command Line Interface
Configuration Manual, 06/2015, C79000-G8976-C406-02
Hide quick links:
Advertisement
Table of Contents
