Security and authentication
9.2 Firewall
9.2.4.37
service name
Description
With this command, you configure a service. You select a service name and assign the
service parameters to it.
Requirement
You are in the Firewall configuration mode.
The command prompt is as follows:
cli(config-fw)#
Syntax
Call up the command with the following parameters:
service name <string(32)> proto {udp|tcp}
src {all| port <number(0-65535)>| range <number(0-65535)> - <number(0-65535)>}
dst {all| port <number(0-65535)>| range <number(0-65535)> - <number(0-65535)>}
The parameters have the following meaning:
Parameter
string
UDP
TCP
src
all
Port
number
range
number
number
dst
all
Port
number
348
Description
Service name
The service is valid only for UDP
frames.
The service is valid only for TCP
frames.
Keyword for the source
Applies to all ports.
Keyword for a port
Port number
Keyword for a port range
Start port
End port
Keyword for the destination
Applies to all ports.
Keyword for a port
Port number
Range of values / note
Specify a unique service name.
Maximum of 32 characters
-
Default
-
-
-
0 ... 65535
Specify the required port.
-
0 ... 65535
Specify the start port and end port, e.g.
10 - 20
-
-
-
0 ... 65535
Specify the required port.
SCALANCE S615 Command Line Interface
Configuration Manual, 06/2015, C79000-G8976-C406-02