No Napt - Siemens SCALANCE S615 Configuration Manual

Layer 3 functions
8.1 NAT
For information on identifiers of addresses and interfaces, refer to the section "Commands in
the FIREWALL NAT configuration mode (Page 288)".
Note
If the port is already occupied by a local service, for example Telnet, a warning is displayed.
In this case, avoid using the following ports: TCP port 23 (Telnet), port 22 (SSH), the ports
80/443 (http/https: reachability of the client with the WBM), UDP port 161 (SNMP), port 500
(ISAKMP), port 4500 (IPsec Nat-T).
Result
The NAPT rule is created. During creation, an entry with a unique number (index) is created.
Further notes
You delete a NAPT rule with the
You delete all NAPT rules with the
You display the numbers of the NAPT rules with the
You display the NAPT rule with the
8.1.3.4

no napt

Description
With this command, you delete a specific NAPT rule.
Requirement
● VLAN interface with subnet assignment
● You are in the FIREWALL NAT configuration mode.
The command prompt is as follows:
cli(config-fwnat)#
Syntax
Call up the command with the following parameters:
no napt srcint <vlan> <num(0-4094)> idx <num(1-200)>
The parameters have the following meaning:
Parameter
srcint
if-type
292
command.
no napt
no napt all
show firewallnat napt
Description
Keyword for the source interface
Type or speed of the interface
command.
command.
napt show-idx
command.
Range of values / note
-
Specify a valid interface.
SCALANCE S615 Command Line Interface
Configuration Manual, 06/2015, C79000-G8976-C406-02