Local-Id - Siemens SCALANCE S615 Configuration Manual

Security and authentication
9.3 IPsec VPN
Requirement
You are in the IPSEC AUTHENTICATION configuration mode.
The command prompt is as follows:
cli(config-conn-auth)#
Syntax
Call the command without parameter assignment:
no auth
Result
The authentication method is deleted.
9.3.6.5

local-id

Description
With this command, you configure the local ID.
Requirement
You are in the IPSEC AUTHENTICATION configuration mode.
The command prompt is as follows:
cli(config-conn-auth)#
Syntax
Call up the command with the following parameters:
local-id <string(255)>
The parameter has the following meaning:
Parameter
string
Result
The local ID is configured.
382
Description Range of values / note
Local ID Enter the local ID.
If you do not specify the local ID, the local ID is read from the device
certificate.
If you use PSK as the authentication, the WAN IP address is used as the
local ID.
SCALANCE S615 Command Line Interface
Configuration Manual, 06/2015, C79000-G8976-C406-02