Prerule Http Ipv4 - Siemens SCALANCE S615 Configuration Manual

Security and authentication
9.2 Firewall
For information on identifiers of addresses and interfaces, refer to the section "Commands in
the FIREWALL configuration mode".
Result
The predefined firewall rule DNS is enabled on the relevant interface. DNS queries to the
device are possible via the interface.
Further notes
You display this setting and other information with the
command.
You list the available interfaces with the
See also
Commands in the FIREWALL configuration mode (Page 313)
9.2.4.25

prerule http ipv4

Description
With this command, you enable the predefined firewall rule HTTP on the selected interface.
Requirement
You are in the FIREWALL configuration mode.
The command prompt is as follows:
cli(config-fw)#
Syntax
Call up the command with the following parameters:
prerule http ipv4 {int <interface-type> <num(0-10)> | all-int} {enabled|disabled}
The parameters have the following meaning:
Parameter
int
interface-type
num
all-int
336
prerule ipv4 show-int
Description
Keyword for the interface
Type or speed of the interface
Interface index
Enables the predefined firewall rule on all inter-
faces.
show firewall pre-rules ipv4
command.
Range of values / note
-
Specify a valid interface.
Specify a valid interface
index.
0 ... 10
-
SCALANCE S615 Command Line Interface
Configuration Manual, 06/2015, C79000-G8976-C406-02