Commands In The Ipsec Phase2 Configuration Mode; Auto-Fwrules - Siemens SCALANCE S615 Configuration Manual

Security and authentication
9.3 IPsec VPN
Requirement
You are in the IPSEC PHASE configuration mode.
The command prompt is as follows:
cli(config-conn-phs1)#
Syntax
Call up the command with the following parameters:
ike-lifetime <min(10-2500000)>
The parameter has the following meaning:
Parameter
min
Result
The period of time is configured.
Further notes
You display this setting and other information with the
9.3.8

Commands in the IPSEC PHASE2 configuration mode

This section describes commands that you can call up in the IPSEC PHASE configuration
mode.
In the IPSEC CONNECTION configuration mode, enter the
this mode.
● If you exit the IPSEC PHASE2 configuration mode with the
the IPSEC CONNECTION configuration mode.
● If you exit the IPSEC PHASE2 configuration mode with the
the Privileged EXEC mode.
9.3.8.1

auto-fwrules

Description
With this command you specify that the firewall rule will be created automatically for the VPN
connection.
396
Description
Period for DPD queries
Range of values / note
Specify the period of time in
minutes.
show ipsec conn-phase1
command to change to
phase 2
command, you return to
exit
command, you return to
end
SCALANCE S615 Command Line Interface
Configuration Manual, 06/2015, C79000-G8976-C406-02
command.