Syntax
Call up the command with the following parameters:
prerule telnet ipv4 {int <interface-type> <num(0-10)> | all-int} {enabled|disabled}
The parameters have the following meaning:
Parameter
int
interface-type
num
all-int
enabled
disabled
For information on identifiers of addresses and interfaces, refer to the section "Commands in
the FIREWALL configuration mode (Page 313)".
Result
The predefined firewall rule Ping is enabled on the relevant interface.
Further notes
You display this setting and other information with the
command.
You list the available interfaces with the
9.2.4.34
proto name
Description
With this command, you configure user-defined protocols. You select a protocol name and
assign a protocol number to it.
Requirement
You are in the FIREWALL configuration mode.
The command prompt is as follows:
cli(config-fw)#
SCALANCE S615 Command Line Interface
Configuration Manual, 06/2015, C79000-G8976-C406-02
Description
Keyword for the interface
Type or speed of the interface
Interface index
Enables the predefined firewall rule on all inter-
faces.
Enables the predefined firewall rule.
Disables the predefined firewall rule.
prerule ipv4 show-int
Security and authentication
Range of values / note
-
Specify a valid interface.
Specify a valid interface
index.
0 ... 10
-
-
-
show firewall pre-rules ipv4
command.
9.2 Firewall
345