Acura 3.5 RL Manual page 353

1996 - 2004 years
Table of Contents

Advertisement

II.
Powertrain Control Module (PCM) Reset Procedure
NOTE: The PCM memory setting is needed after resetting the PCM (see page 11-125).
Either of the following actions will reset the PCM.
• Use the OBD II scan tool or Honda PGM Tester to clear the PCM's memory.
NOTE: See the OBD II scan tool or Honda PGM Tester user's manuals for specific operating instructions.
• Turn the ignition switch OFF. Remove the BACK UP RADIO (7.5 A) fuse from the under-hood fuse/relay box for
10 seconds.
NOTE: If the BACK UP RADIO (7.5 A) fuse is removed and the ignition switch ON (II), MIL will report on and
PCM will store the DTC P0560.
III.
Final Procedure (this procedure must be done after any troubleshooting)
1. Remove the SCS service connector if it is connected.
NOTE: If the SCS service connector is connected and there are no DTCs stored in the PCM, the MIL will stay
on when the ignition switch is turned ON (II).
2. Do the PCM Reset Procedure.
3. Turn the ignition switch OFF.
4. Disconnect the OBD II scan tool or Honda PGM Tester from the Data Link Connector.
BACK UP RADIO
(7.5 A) FUSE
UNDER-HOOD
FUSE/RELAY
BOX

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ka9

Table of Contents