Acura 3.5 RL Manual page 393

PGM-FI System
MIL Circuit Troubleshooting (cont'd)
(From page 11-63)
Check for an open in the wire or
bulb (MIL line):
1. Turn the ignition switch OFF.
2. Connect PCM connector ter-
minal A7 and body ground
with a jumper wire.
3. Turn the ignition switch ON (II).
Does the MIL come on?
YES
Substitute a known-good PCM
and recheck (see page
immobilizer information). If
symptom/indication goes away,
replace the original PCM.
— Repair open in the wires
NO
between the PCM (A7) and
gauge assembly.
— Replace the MIL bulb.
11-42 for
PCM CONNECTOR A (26P)
JUMPER WIRE
MIL (LT GRN/RED)
Wire side of female terminals