Acura 3.5 RL Manual page 259

Oil Pump
Removal/lnspection/lnstallation (cont'd)
20. Install the oil pump to the cylinder block.
OIL PUMP
O-RINGS
Replace.
6 x 1.0 mm
12 N-m (1.2 kgf-m,
8.7 Ibf-ft)
8 x 1.25 mm
22 N-m (2.2 kgf-m,
16 Ibf-ft)
21. Install the oil pan (see page 8-10).
22. Apply engine oil to the balancer shaft, then insert
the balancer shaft.
NOTE: Take care not to damage the journals when
installing the balancer shaft.
DOWEL PIN
DOWEL PIN
BALANCER
SHAFT
23. Install the balancer shaft holder (see page 7-3).
NOTE: Apply liquid gasket around the oil hole to
the block mating surface.
24. Install the rear balancer weight.
25. Hold the balancer shaft as shown below, then tighten
the bolt.
26. Install the balancer shaft rear cover.
BALANCER SHAFT
REAR COVER
O-RING
Replace.
8 x 1.25 mm
25 N-m (2.5 kgf-m,
18 Ibf-ft)
6 x 1.0 mm
12 N-m (1.2 kgf-m,
8.7 Ibf-ft)