Chrysler 2005 Crossfire SRT6 Service Manual page 140

3 - 24 HALFSHAFTS
2. Install the C/V joint assembly onto the axle half-
shaft by using a soft–faced hammer and tapping
the end of the stub axle until the C/V joint is fully
seated on the axle halfshaft.
Note: The C/V joint assembly must be installed on
axle halfshaft until the C/V joint assembly is
seated against the circlip on the halfshaft.
Note: Do not use any other type of grease other
than what is supplied in the C/V boot service
package.
3. Pack approximately 1/2 the amount of grease pro-
vided in the C/V boot service package into the
outer C/V joint cavity.
4. Pack the remaining amount of grease into the C/V
boot.
Note: The C/V boot must be positioned on the axle
halfshaft so the raised bead on the inside of the
C/V boot is in the groove on the axle halfshaft.
5. Install the C/V boot outer end into the sealing
groove (1) of the C/V joint housing.
6. Install the C/V boot inner end into the sealing
groove of the axle halfshaft.
ZH