Chrysler 2005 Crossfire SRT6 Service Manual page 200

5 - 34 BRAKES - BASE
7. Connect the brake wear indicator to the brake pad.
8. Install one end of the caliper support spring (2) in the top end of the caliper and under the mounting bracket (1).
9. Install the other end into the lower caliper hole (3).
10. Hold the spring (2) into the caliper hole (3) with
your thumb while prying the end of the spring (2)
out and down under the mounting bracket with a
screwdriver.
CAUTION: Verify brake hose is not twisted or
kinked before tightening the fitting.
11. Connect the brake hose (4) to the caliper (3).
12. Fill and bleed brake system.
• Manual bleeding: (Refer to 5 - BRAKES - STAN-
DARD PROCEDURE).
• Pressure bleeding: (Refer to 5 - BRAKES -
STANDARD PROCEDURE).
13. Install the wheel and tire assembly. (Refer to 22 -
TIRES/WHEELS - STANDARD PROCEDURE).
WARNING: DO NOT MOVE THE VEHICLE UNTIL A
FIRM BRAKE PEDAL IS ACHIEVED.
14. Lower the vehicle.
ZH