3 - 32
PROPELLER SHAFT
8. Install the transmission tunnel support bracket.
9. Install the transmission tunnel support bracket bolts
(1). Tighten the bolts to 20 N·m (15 ft. lbs.).
10. Position the transmission crossmember and trans-
mission mount on the vehicle.
11. Install the transmission mount bolts (1). Tighten
the bolts to 45 N·m (33 ft. lbs.).
12. Install the transmission crossmember bolts (2).
Tighten the bolts to 45 N·m (33 ft. lbs.).
13. Install the rear exhaust heat shield and nuts (1).
Tighten the nuts to 10 N·m (89 in. lbs.).
14. Remove the jack stand supporting the transmis-
sion.
15. Install the exhaust system. (Refer to 11 -
EXHAUST SYSTEM/CATALYTIC CONVERTER -
INSTALLATION).
16. Lower the vehicle.
ZH