Configuration Of The Ibm Iscsi Server Adapter Card - IBM TotalStorage DS300 Best Practices Manual

Figure 7-256 SANsurfer Linux installation step 7

7.6.5 Configuration of the IBM iSCSI Server Adapter Card

The IBM iSCSI Server Adapter Card can be configured in its BIOS during system
POST (by pressing CTRL+Q) or with the iSCSI SANsurfer Management
Software.
The configuration is almost the same as described in 7.2.3, "Setup of the QLogic
iSCSI Expansion Card for IBM eServer BladeCenter" on page 291. The only
difference is that the IBM iSCSI Server Adapter Card is a single port card. So in
the SANsurfer iSCSI HBA manager application appears a single port for each
installed HBA.
Figure 7-257 on page 386 shows SANsurfer on a system with two installed IBM
iSCSI Server Adapter cards.
385
Chapter 7. TotalStorage DS300 installation