IBM TotalStorage DS300 Best Practices Manual page 284

a. Select the second port of the HBA. The second port is port 1. From the
right column select the Port Options tab. This port does not have an IP
address configured.
Figure 7-63 SANsurfer — Port1 - port options
b. Enter in the IP address field the IP address 192.168.1.69. Enter the
Subnetmask 255.255.255.192 in the Subnet Mask field. Then click Save
Port Settings.
Note: You may see a BSoD when the network settings are applied to the
adapter. Applying network addresses to the adapter is resetting this
adapter and this interrupts the access of the operating system to the C
drive. It is safer to perform this configuration from the adapter BIOS.
266
IBM TotalStorage DS300 and DS400 Best Practices Guide