Open the iSCSI Initiator properties dialog by starting iSCSI Initiator in the
control panel. Execute the following steps to do the configuration:
1. The initiator node name is shown in the General tab. The logical drives on the
DS300 that are used must allow access to the logical drives from this initiator.
Figure 7-281 Microsoft iSCSI software initiator 2.0 configuration step 1
2. In the Discovery tab it is possible to search for targets by adding IP
addresses of target portals or by specifying an iSNS server. Click Add in the
appropriate area to add a target portal or an iSNS server. This example
shows the configuration by using an iSNS server.
402
IBM TotalStorage DS300 and DS400 Best Practices Guide