k. Reset the first HBA to factory default. Perform Step c on page 511 to
Step f on page 513.
3. Verify that the first adapter can see one port of each controller.
a. Select Scan Fibre Devices from Configuration Settings and press
Enter.
Figure 9-104 Fast!UTIL Options
b. A list with all detected devices will be shown. The list needs two entries for
a connected TotalStorage DS400. One for one port of controller A and one
for one port of controller B. The port name can be used to identify the
TotalStorage DS400. The last 8 digits of the port name are identifying the
TotalStorage DS400 across both controllers and ports. The third and
fourth digit identifies the port to which the HBA has a connect. The screen
shows that the first HBA sees ID 129 which is the Controller A port FC0
(A0) and ID 130 which is the Controller B port FC0 (B0). This screen will
only show the target devices but no LUNs.
516
IBM TotalStorage DS300 and DS400 Best Practices Guide