IBM TotalStorage DS300 Best Practices Manual page 350

7.5.5 Configure arrays and logical drives on the TotalStorage DS300
This section describes the configuration using the command line interface of the
TotalStorage DS300. See 7.5.1, "Planning and considerations" on page 319 for
details of the configuration.
1. Open a Telnet session to one of the controllers.
2. Logon as administrator.
3. Create the initiator definition by issuing the command initiator create.
initiator create TIBER-HBA0 iqn.2000-04.com.qlogic:qla4010.fs20430a05865
initiator create TIBER-HBA1 iqn.2000-04.com.qlogic:qla4010.fs20432a07396
initiator create SEINE-HBA0 iqn.2000-04.com.qlogic:qla4010.fs20417a03127
initiator create SEINE-HBA1 iqn.2000-04.com.qlogic:qla4010.fs20417a02573
Figure 7-160 Define initiators on the TotalStorage DS300
4. Create a user account with that the initiator can authenticate on the
TotalStorage DS300.
Note: The IQN is the default username used by the Microsoft Software
Initiator. it is possible to change this user.
After entering this command enter the password twice.
authentication add elbe
Figure 7-161 Create a user account on the TotalStorage DS300
5. Create the arrays. The parameter remote specifies that the array is owned by
the alternate controller.
array create ELBE-Quorum raid1 65536 65792
array create ELBE-Exchange raid1 3584 3840
array create ELBE-DB remote Raid1 2304 2560
array create ELBE-Domino remote Raid1 3072 3328
Figure 7-162 Create arrays
6. Create the logical drives in the arrays.
332
IBM TotalStorage DS300 and DS400 Best Practices Guide