Driver And Service Pack Installation And Finishing The Setup - IBM TotalStorage DS300 Best Practices Manual

Figure 9-123 Windows setup — Supported mass storage drivers
7. For the remaining installation follow the instructions on the screen. There is
no difference from the installation to a local attached drive.

9.2.7 Driver and service pack installation and finishing the setup

Install the Broadcom network driver for the adapter. Broadcom NetXtreme
Gigabit Ethernet #2 is connected to the port number 1. This port is also shared
by the baseboard management controller (BMC). This port might be connected
into a management network. Broadcom NetXtreme Gigabit Ethernet is routed to
port number 2. This is the port close to the power supplies.
There are operating system install instructions for all IBM IBM ^xSeries
server on the support pages. See Appendix C, "How to get updates of code and
documentation" on page 623.
8. Install the service pack1 for Microsoft Windows Server 2003. Reboot the
server.
http://www.ibm.com/pc/support/site.wss/document.do?sitestyle=ibm&lndocid=MI
GR-58619
9. Install remaining drivers not available during operating system installation:
a. Install the Intel chipset drivers.
b. Install ActivePCI.
Chapter 9. TotalStorage DS400 installation
533