IBM TotalStorage DS300 Best Practices Manual page 563

DS400[A]# initiator manage WOLGA-SLOT3-(0) info
----[ Initiators ]---------------------------------------------------------
----[ Initiator 'WOLGA-SLOT3-(0)' ]----------------------------------------
WWN: 210000e08b0ff748
Alias: WOLGA-SLOT3-(0)
ID: 4
Port access:
---------------------------------------------------------------------------
LUN Mappings:
LUN
----------------------------------------------------------------------------
0
1
2
3
4
DS400[A]#
Figure 9-143 Initiator information
6. Enable the remaining ports with initiator manage WOLGA-SLOT3-(0) allow A1
B0 B1.
DS400[A]# initiator manage WOLGA-SLOT3-(0) allow all
Access allowed to initiator WOLGA-SLOT3-(0) on A1, B0 and B1
DS400[A]#
Figure 9-144 Enable initiator access to all ports
7. Reboot the server and verify after reboot that you see twenty drives in the
device manager and five multipath device.
IBM FAStT MSJ shows four targets and every target has five LUNs. This is as
expected.
Port A0 Port A1
YES NO
logical
WOLGA-BOOT
WOLGA-DB
WOLGA-LOG
WOLGA-MEDIA
WOLGA-TEMP
Chapter 9. TotalStorage DS400 installation
Port B0 Port B1
NO NO
[Capacity]
[ 30.00GB]
[ 15.00GB]
[ 11.01GB]
[100.00GB]
[900.00MB]
545