IBM TotalStorage DS300 Best Practices Manual page 595

Hide thumbs Also See for TotalStorage DS300:

Table of Contents

[local | foreign | virtualized | alien | remote]

name (See Array manage array commands)

local | remote name_list

RAID_array device_list

start | stop

rate high | low | medium

create name [remote] raid_level [options] device_list

Create a new array called name with no RAID and enter a list of devices to add to

the new array. The name must not be the name of any other array.

create name raid0 stripe-depth device_list

Create a RAID 0 array with the specified stripe depth and devices. You must

specify at least two devices.

create name raid1 device_list

Create a RAID 1 array with the two specified devices. You must specify exactly

two devices.

create name raid5 stripe-depth device_list

Create a RAID 5 array with the specified stripe depth and devices. You must

specify at least three devices.

create name raid10 stripe-depth device_list

Create a RAID 10 array with the specified stripe depth and devices. Devices are

automatically grouped into pairs, and therefore must always be an even number.

create name raid50 stripe-depth device_list group num_group

Create a RAID 50 array with the specified stripe depth and devices. You must

specify at least six devices and arrange them into groups. The number of groups

is specified by the group parameter.

Appendix A. Command line interface reference

administrator

administrator

Administrator

Totalstorage ds400