IBM TotalStorage DS300 Best Practices Manual page 561

1. Open a Telnet connection to one of the controllers in the DS400 and logon as
administrator. To logon with administrative rights enter administrator.
----[ IBM DS400: Command Line Interface ]----------------------------------
Copyright: IBM (c)2003-2004
Firmware: IBM TotalStorage DS Series (Build 0743)
Peer controller status: Ready
Typing 'help': provides an overview of the commands available to
TAB key: use the TAB key as a means of getting assistance
DS400[A]> administrator
Administrator level password: ********
DS400[A]#
Figure 9-139 Logon as administrator
2. Get a list of the available initiators by entering initiator list.
DS400[A]# initiator list
Fibre Channel Initiators
210000e08b0f1549
210000e08b0ff748
210000e08b170d75
210000e08b17d774
DS400[A]#
Figure 9-140 List initiators
3. Look for the initiators of WOLGA and check port access for every singly initiator
by entering initiator manage WOLGA-SLOT4-(1) info. All ports are disabled for
this initiator.
[20/07/2005][6.21]
configure the controller.
in completing any commands that you issue.
[WOLGA-SLOT4-(1)]
[WOLGA-SLOT3-(0)]
[RIOGRANDE-S4-(1)]
[RIOGRANDE-S3-(0)]
Chapter 9. TotalStorage DS400 installation
543