IBM TotalStorage DS300 Best Practices Manual page 607

them by events inactive or after the events global commands by preceding
them by inactive.
Except for the all command, any number of these commands can be combined
on a line to define the set of events that will be selected. Each command restricts
the number of events that are selected.
The selected events will be listed and you will be asked for confirmation before
they are set inactive. At least one command must be supplied for a report to be
generated.
Command Parameters
all Cannot be combined with other parameters
from absolute_date | relative_period
level See list of valid levels.
originator name
to absolute_date | relative_period
all
Select every event. It must be the only command on the line.
from absolute_date | relative_period
Only report events which were generated at or after the time and date specified
by the supplied value. All the reports from the specified time and date to the
present will be reported unless the for or to commands further restrict the
reported events to a range of dates and times.
The relative_period is the period before the current time and date.
level
See list of valid levels.
originator name
Only select events that were originated by name.
to absolute_date | relative_period
Restrict the events that are selected to those which occurred before the date and
time given by the value. All reports from the oldest stored event up to the
Appendix A. Command line interface reference
Levels
administrator
administrator
administrator
administrator
administrator
589