Install The Device Drivers For The Qlogic Iscsi Expansion Card For Ibm; Eserver Bladecenter - IBM TotalStorage DS300 Best Practices Manual

Hide thumbs Also See for TotalStorage DS300:

Table of Contents

the management network. Microsoft Internet Storage Name Server 3.0 was

chosen for the iSNS server. The iSNS server needs to be defined on the DS300

with the command line interface. IBM ServeRAID Manager does not provide the

capability to define this setting. The iSNS Server and the ServeRAID Manager

management station service might be run on the same system.

The following diagram shows the cabling of the components. It follows the

example configuration as explained in 6.2.2, "DS300 dual controller switched

dual path attachment" on page 219.

Figure 7-80 Configuration setup

7.2.1 Install the device drivers for the QLogic iSCSI Expansion Card

for IBM eServer BladeCenter

For the card there will appear four devices in the Other devices tree of the

Device Manager:

Chapter 7. TotalStorage DS300 installation

Totalstorage ds400