Host Bus Adapter Setup And Installation Preparation - IBM TotalStorage DS300 Best Practices Manual

DS400[A]# initiator manage RIOGRANDE-S4-(1) info
----[ Initiators ]---------------------------------------------------------
----[ Initiator 'RIOGRANDE-S4-(1)' ]---------------------------------------
---------------------------------------------------------------------------
---------------------------------------------------------------------------
DS400[A]#
Figure 9-7 Initiator information

9.1.4 Host bus adapter setup and installation preparation

The IBM SMB Host Bus Adapter has limited functionality compared with a IBM
DS4000 host bus adapter. Please see "IBM TotalStorage SMB Host Bus Adapter
(QLA200) 13N1873" on page 62 for more details.
The following steps are done to configure the IBM SMB Host Bus Adapters in the
x236.
1. Update BIOS and firmware of the HBA to a supported level by IBM. During
our setup, the BIOS level 1.23 was used.
http://www.ibm.com/pc/support/site.wss/document.do?sitestyle=ibm&lndocid=MI
GR-58619
2. Reset the HBA to adapter defaults.
a. During POST, the BIOS of the IBM SMB Host Bus Adapter displays a
message. Press Ctrl+Q to access Setup. Figure 9-8 on page 456.
WWN: 210000e08b170d75
Alias: RIOGRANDE-S4-(1)
ID: 3
Port access:
Port A0
NO
LUN Mappings:
LUN
0
1
Port A1 Port B0
NO NO
logical [Capacity]
RIOGRANDE-BOOT [ 10.00GB]
RIOGRANDE-BOOT2 [9000.00MB]
Chapter 9. TotalStorage DS400 installation
Port B1
NO
455