Figure 4-167 Hyperterminal — Send file
7. The firmware file will be transferred to the controller. This dialog will close
after successful transmission or because to many errors.
Figure 4-168 Hyperterminal — transfer firmware data
8. After the firmware file was successful transferred the command line interface
informs about the next steps. The firmware is written to the controller.
27302294 bytes read...
RedBoot already at version 05.05.05, skipping...
Writing kernel
Writing filesystem
27302294 bytes read...
Image successfully uploaded.
Use the 'system reboot' command to run this new firmware image
DS300-1[A]#
Figure 4-169 Command line interface — successful image flash
184
IBM TotalStorage DS300 and DS400 Best Practices Guide