Figure 7-173 SANsurfer — Defined network settings
10.Repeat step 5 on page 334 to step 9 on page 336 for each remaining host
bus adapters in both cluster nodes. See table Table 7-6 on page 322 and
Table 7-7 on page 323 for network address details.
11.After the network configuration for each host bus adapter is done, the
firmware settings ARP Redirect and Connection Keep Alive timeout must
to be changed before LUNs can be bound to the adapter.
Note: In case LUNs are already bound to an adapter, this binding needs to
be deleted and reestablished to use the modified firmware settings.
Select port 0 of HBA0 of host SEINE. Then click register card Port Options
and Firmware. Click the button Open to see configured firmware values.
Chapter 7. TotalStorage DS300 installation
337