Interface Commands - IBM TotalStorage DS300 Best Practices Manual

Hide thumbs Also See for TotalStorage DS300:

Table of Contents

Output information about the specified remote FC initiator.

move old_LUN new_LUN

Change the mapping of a volume to a new LUN.

Remove the mapping that contains LUN LUN.

rename old_name new_name

Give a FC initiator a new user label.

A.18 Interface commands

These commands are available after the interface global command has been

executed and deal with interface options in general. They can also be run as

global commands by preceding them by interface.

Interfaces are specified by their hardware names (such as eth0), unless you have

renamed them using the interface rename command (see rename name).

failback [failed-over_interface_list]

If the IP addresses of any iSCSI interfaces have been transferred (failed over) to

another interface because of problems, this command will restore them to their

original interface (assuming the problems have been fixed).

[failed-over_interface_list]

[ interface_list ]

interface (See interface manage commands)

[ interface_list ]

Appendix A. Command line interface reference

Totalstorage ds400