Totalstorage Ds300 And Ds400 Command Line Interface (Cli) - IBM TotalStorage DS300 Best Practices Manual

4.2 TotalStorage DS300 and DS400 command line
interface (CLI)
The command line interface (CLI) is accessed via a Telnet session to one of the
password
management ports of the controllers installed in the DS300/DS400. By default
operator
you have access as operator without the need for a password. You can get
information about the health of your storage subsystem. A password can be
assigned to the operator account to limit the access to persons who have the
need for access.
Entering the command administrator gives you administrative rights to manage
the storage subsystem. You need a password to authenticate. By default is the
TotalStorage DS300 and DS400 shipped with the administrator password
PASSW0RD (with a zero instead a O, all capital letters).
Note: Some firmware versions have a setup wizard which sets the password
of the administrator to passw0rd.
Help can be retrieved in the command line interface by entering the command
help. A list with the available command in the current section are provided. The
example shows all command available in interface.
DS300-1[A] (interface)# help
manage network interfaces
failback
info
list
manage
statistics
interfaces
end
quit
help/?
DS300-1[A] (interface)#
Figure 4-1 Help for interface
fail back interfaces to their original controller
show information for some or all interfaces
list all interfaces
manage an individual interface
show throughput information for some or all
leave this context and return to main mode
leave the CLI
display this output
Chapter 4. TotalStorage DS300 and DS400 management
69