IBM TotalStorage DS300 Best Practices Manual page 500

1. Open a Telnet connection to one of the controllers in the DS400 and logon as
administrator. Enter Telnet 192.168.1.226. To logon with administrative rights
enter administrator.
----[ IBM DS400: Command Line Interface ]----------------------------------
Peer controller status: Ready
DS400[A]> administrator
Administrator level password: ********
DS400[A]#
Figure 9-53 Logon
2. Get a list of the available initiators by entering initiator list.
DS400[A]# initiator list
Fibre Channel Initiators
210000e08b0f1549
210000e08b0ff748
210000e08b170d75
210000e08b17d774
DS400[A]#
Figure 9-54 Initiator list
3. Look for the initiators of RIOGRANDE and check port access for every singly
initiator by entering initiator manage RIOGRANDE-S4-(1) info. All ports are
disabled for this initiator.
482
IBM TotalStorage DS300 and DS400 Best Practices Guide
Copyright: IBM (c)2003-2004
Firmware: IBM TotalStorage DS Series (Build 0743)
[20/07/2005][6.21]
Typing 'help': provides an overview of the commands available to
configure the controller.
TAB key: use the TAB key as a means of getting assistance
in completing any commands that you issue.
[WOLGA-SLOT4-(1)]
[WOLGA-SLOT3-(0)]
[RIOGRANDE-S4-(1)]
[RIOGRANDE-S3-(0)]