Figure 7-130 SANsurfer Linux installation step 7
7.3.3 Configuration of the QLogic iSCSI Expansion Card for IBM
eServer BladeCenter
The Qlogic iSCSI Expansion Card for IBM ^ BladeCenter can be
configured in its BIOS during system POST (by pressing CTRL+Q) or with the
iSCSI SANsurfer Management Software.
The configuration is almost the same as described in 7.2.3, "Setup of the QLogic
iSCSI Expansion Card for IBM eServer BladeCenter" on page 291.
Figure 7-131 on page 309 shows SANsurfer on a system with two installed IBM
iSCSI Server Adapter cards.
308
IBM TotalStorage DS300 and DS400 Best Practices Guide