IBM TotalStorage DS300 Best Practices Manual page 424

Figure 7-287 Microsoft iSCSI software initiator 2.0 configuration step 7
8. Activate Automatically restore this connection when the system boots
and Enable multi-path. Click Advanced to configure the details.
Figure 7-288 Microsoft iSCSI software initiator 2.0 configuration step 8
9. In the General tab of the Advanced Settings dialog choose the appropriate
values for the
source IP and the target portal are both in the same subnet. In our example
the source IP and the target portal are in iSCSI LAN 2 (see Table 7-1 on
page 224). If you are using CHAP authentication, activate the checkbox for
CHAP and enter username and target secret. Click OK to close the advanced
settings dialog. Then click OK to close the log on to target dialog.
406
IBM TotalStorage DS300 and DS400 Best Practices Guide
second path in the connect by using area. Ensure that the