IBM TotalStorage DS300 Best Practices Manual page 97
Hide thumbs
Also See for TotalStorage DS300:
- Hardware installation and user's manual (114 pages) ,
- Quick installation manual (13 pages) ,
- Quick installation manual (6 pages)
Table of Contents
Advertisement
the system should be sent. Enter no to clear the default
gateway.
DNS servers
Enter the IP numbers of up to 3 systems that will act as
DNS servers. Enter no to clear the list of DNS servers.
Only 2 DNS servers can be configured by the ServeRAID
manager. The third server will not be visible or
changeable from ServeRAID Manager console.
Use DHCP
Reply yes or no to determine whether DHCP should be
used to discover the system's network values. If you enter
yes, the wizard takes you to the Finish question. If you
enter no, the wizard continues with questions about the
systems management ethernet interface and the peer
interface in case of a dual controller DS300 or DS400.
IP address
Enter the IP number in the conventional dotted quad
format as shown in this example: 192.193.194.195. This
will set the IP address of the controller where the Telnet
session is connected to.
Netmask
Define the size of the netmask of the management
interface. A netmask can be represented in a number of
ways. The examples shown here all refer to the same
netmask: /23 The number of bits set in the network part.
255.255.254.0 The set bits displayed in the same way as
an IP number 0xfffffe00 The mask show as a hex number
Broadcast Address
Enter the address to be used for broadcasts for the
management interface where the Telnet session is
connected to.
Peer IP address
Enter the IP number in the conventional dotted quad
format as shown in this example: 192.193.194.195. This
will set the IP address of the alternate controller.
Peer Netmask
Define the size of the netmask of the management
interface of the alternate controller.
Peer Broadcast Address
Enter the address to be used for broadcasts management
interface of the alternate controller.
Finish?
Enter yes to apply the values you have entered, or no to
return to the first question and change the values you
have entered.
Note: If you changed the IP address, you must Telnet to the new IP address to
reestablish the Telnet session.
Chapter 4. TotalStorage DS300 and DS400 management
79
Advertisement
Table of Contents
