Administrator Command; Array Commands - IBM TotalStorage DS300 Best Practices Manual

save new configuration
When the Setup Wizard has finished, the system is configured but the new
configuration is not saved immediately in non-volatile memory. Enter yes to save
the configuration immediately, or no to defer saving the configuration.
The save command saves the configuration.
Finish?
Enter yes to apply the values you have entered, or no to return to the first
question and change the values you have entered.
A.4 Administrator command
Use this command to enter administrator level. If a password has been defined,
you are prompted for that password.
This command is a global command and is always available.
Note: The factory default password is passw0rd (note the number zero not the
letter O). For security reason you should change the PW.
A.5 Array commands
These commands control device arrays. They are available after the global array
command, or as global commands by preceding them by array.
Command
create
migrate
Destroy
export
failback
Identify
import
info
576
IBM TotalStorage DS300 and DS400 Best Practices Guide
Parameters
name [remote] raid_level [options] device_list
[array] raid_level [stripe_depth] device_list
unused_or_alien_array_list (requires confirmation)
name_list (requires confirmation)
[start | stop] name_list
foreign_array_list
[name_list]
Levels
administrator
administrator
administrator
administrator
all
administrator
all