Connecting Fibre Channel Cables To A Fibre Channel Adapter In The Enclosure; Example Storwize V5010 Configuration With 10 Gbps Iscsi-Fcoe 4-Port Host Interface Adapters; Example Storwize V5020 Configuration With 10 Gbps Iscsi-Fcoe 4-Port Host Interface Adapters; Example Storwize V5030 Configuration With 10 Gbps Iscsi-Fcoe 4-Port Host Interface Adapters - IBM Storwize V5000 Gen2 Quick Installation Manual

Results
Figure 131 on page 124 shows an example Storwize V5010 configuration that uses 10 Gbps iSCSI-FCoE
4-port host interface adapters.
Figure 131. Example Storwize V5010 configuration with 10 Gbps iSCSI-FCoE 4-port host interface
adapters
Figure 132 on page 124 shows an example of a Storwize V5020 configuration that uses 10 Gbps iSCSI-
FCoE 4-port host interface adapters.
Figure 132. Example Storwize V5020 configuration with 10 Gbps iSCSI-FCoE 4-port host interface
adapters
Figure 133 on page 124 shows an example of a Storwize V5030 configuration that uses 10 Gbps iSCSI-
FCoE 4-port host interface adapters.
Figure 133. Example Storwize V5030 configuration with 10 Gbps iSCSI-FCoE 4-port host interface
adapters

Connecting Fibre Channel cables to a Fibre Channel adapter in the enclosure

If optional Fibre Channel host interface adapters are installed in your system, use Fibre Channel cables to
connect the two node canisters in the enclosure to the switches in the Fibre Channel SAN.
Procedure
To install the cables, complete the following steps.
1. Connect the required number of Fibre Channel cables to the node canisters in the control enclosure.
Both canisters must have the same number of cables connected.
Figure 134 on page 125 shows an example Storwize V5020 system with two Fibre Channel cables
connected to each canister.
124 Storwize V5000 Gen2: Quick Installation Guide