Install The Qlogic Iscsi Expansion Card For Ibm Eserver Bladecenter; Management Software - IBM TotalStorage DS300 Best Practices Manual

12.After finishing the driver installation for the first network controller of the iSCSI
card, the Welcome to the Found New Hardware Wizard will start again.
Repeat the steps 6 to 9 to install the driver for the second network controller
of the iSCSI card.
You have now completed the installation of the device driver for the iSCSI card.
The next step describes the installation of the management software for the
iSCSI card.
7.2.2 Install the Qlogic iSCSI Expansion Card for IBM eServer
BladeCenter management software
To manage the QLogic iSCSI Expansion Card for IBM ^ BladeCenter, a
software package called iSCSI SANsurfer Management is used. Management of
the iSCSI adapter includes configuration and updating the adapter. This
management software consists of a agent installed on the system where the
iSCSI adapter is installed and a client or graphical user interface (GUI). The GUI
can be installed on the same system or on a system used for management
purposes. Multiple agents might be managed by a single client or GUI. Agent
and GUI are currently only for Microsoft Windows available. This document uses
the version 4.01.03 of the iSCSI SANsurfer Management software to
demonstrate installation and configuration. To download the management
software use this URL:
http://www.ibm.com/pc/support/site.wss/document.do?sitestyle=ibm&lndocid=MI
GR-60280
The following steps explain the installation and configuration of the iSCSI
SANsurfer Management software.
1. Run the installer of the management software by executing the downloaded
file.
286
IBM TotalStorage DS300 and DS400 Best Practices Guide