IBM TotalStorage DS300 Best Practices Manual page 267

2. Insert the installation CD into the CD-ROM drive and boot from this CD. After
the message Setup is inspecting your computer was shown, the black screen
will switch to blue and the bottom line will give you the option to press F6 to
install third party SCSI or RAID drives which are required at boot time. Press
F6 to install the driver for the QLogic iSCSI Expansion Card for IBM ^
BladeCenter.
Figure 7-36 Windows setup — Install third party SCSI or RAID drivers
3. Press S to specify additional SCSI or RAID controller driver.
Chapter 7. TotalStorage DS300 installation
249