IBM TotalStorage DS300 Best Practices Manual page 505

boot target. The appropriate LUN must be selected as well. This setting needs to
be defined also for the second host bus adapter to allow booting the system in
case the first HBA fails. Not under all circumstances will this be the case. There
is no failover driver available, therefore you have to configure the second adapter
if there is a failure.
1. Reboot the system. During POST press CTRL+Q when the adapter displays
the message "Press <CTRL+Q> for Fast!UTIL" to enter the host bus adapter
BIOS setup.
Figure 9-61 POST messages of the host bus adapter
2. Select the first HBA and press Enter. See Figure 9-62 on page 488.
Chapter 9. TotalStorage DS400 installation
487