IBM TotalStorage DS300 Best Practices Manual page 96

DS300-1[A]# setup
.
.
.
Figure 4-4 Starting the setup wizard
In the setup wizard, the command back can be used to go back to the previous
question. Command abort will cancel the wizard.
To bring the system back into a default state see 4.4.4, "Reset network and
account setting to factory default" on page 91.
If a question has a predefined or default answer, the answer appears in square
brackets [ ]. Some options take an arbitrary string, in which case the commands
back and abort cannot be used. In those circumstances, enclose the answer in
double-quotes " " so that the answer will be accepted even if it is the same as a
command.
Hostname
Domain name
SAN name
system Date
timezone
New administrator password
New operator password
Default gateway
78
IBM TotalStorage DS300 and DS400 Best Practices Guide
Supply the name by which the system is to be known.The
special BACK command here repeats this prompt.
Supply the domain in which the system belongs.
Supply the Storage Area Network in which the system
belongs.
Supply the system time and date in the format 24
hours:minutes:seconds@day/month/year.
Supply the system time zone. Use capital letters for the
time zone. for example GMT-6 or GMT+1
Define whether an administrator password is required. If a
password is required, you are prompted for that password,
which must be supplied twice. Press Ctrl to leave the
password unchanged. Press Return (or Enter) twice to
require no administrator password.
Define whether an operator password is required.If a
password is required, you are prompted for that password,
which must be supplied twice. Press Ctrl to leave the
password unchanged. Press Return (or Enter) twice to
require no administrator password.
Enter the name or IP number of a router to which packets
for destinations that do not have routes defined for them in