IBM TotalStorage DS300 Best Practices Manual page 617

Command Parameters
speed 10 | 100 | auto
statistics
Up
broadcast broadcast
Set the broadcast address. An explicit value may be given in the conventional
way, for example 192.112.28.255. Alternatively, the special values listed in the
Table above may be entered. These will look at the current address and netmask
and deduce the value to use. The value high sets all of the bits in the host part
and the value low clears them.
This command may be combined with the ip and netmask commands on a single
line. The ip command describes the default value for this option if just the IP
number is changed
If DHCP is enabled this command changes the stored value which will be used if
DHCP is disabled. It does not change the actual value of the interface if DHCP is
enabled otherwise it resets the interface.
info
Show the details about the interface. This includes:
IP number
Netmask
Broadcast address
MAC address
Whether DHCP is enabled
Whether it is configured (up)
The interface's speed
If DHCP is enabled the output will show the active values for the interface plus
the values which will be applied if DHCP is disabled.
dhcp enable | disable
Either enable or disable DHCP depending on the value of the boolean parameter.
ip ip_address [ip_mask]
Specify the IP number for the interface.
Levels
administrator
all
administrator
Appendix A. Command line interface reference
599