Ibm Serveraid Manager Log Files - IBM TotalStorage DS300 Best Practices Manual

Hide thumbs Also See for TotalStorage DS300:

Table of Contents

vii. When the output cannot be collected at once, try the separate sub

DS300-1[A]# show

authentication initiator

DS300-1[A]# show

Figure 4-202 Sub commands of the show command

viii.Run the command events report all. See the command show all for

ix. Repeat these commands on the alternate controller.

e. Save Management Station log files

The Management Station maintains a own set of log files. This log files are

located in the temp directory of the windows installation directory.

Windows installation directory is mostly Windows\Temp or Winnt\Temp. The

log files are called:

• mgmtservice.log

• mgmtservice.log.old

• miniwinagent.log

4.15.5 IBM ServeRAID Manager log files

The IBM ServeRAID Manager maintains a few log files:

RaidEvtA.log

commands of show. Run one command after the other. for example

show array or show system. This is the list of command for a

TotalStorage DS300. Enter show and press TAB to get a list of sub

details. Please note that this can be a very long output.

Contains the information reported in the ServeRAID

Manager event viewer for all local and remote systems.

Contains the information reported in the ServeRAID

Manager event viewer for the local system.

Contains the information reported in the Notification

Manager event viewer.

Contains the information reported in the Security

Manager event viewer.

Chapter 4. TotalStorage DS300 and DS400 management

Totalstorage ds400