IBM TotalStorage DS300 Best Practices Manual page 633

Command Parameters
list [ parent ]
manage snapshot_child (See snapshot manage
snapshot_child commands)
rollback snapshot_child
up snapshot_child
Note: Only logical drives which have been created by the snapshot create
command can be managed by these commands.
create name snapshot_parent [readonly] unrestricted |
restricted [initiator_list]
Create a new snapshot of snapshot_parent to be called name using array.
The snapshot may be specified as restricted to a limited number of initiators
(which you can specify in this command or specify later using the snapshot
manage allow command) or it can be created as unrestricted. You can also
specify access to be read-only.
The create command creates the logical drive, so logical must be a name not
used by any other logical drive (of any type) before.
destroy snapshot_child
Destroys the snapshot of logical drives given in the snapshot_child list and frees
the space from each facet's array.
info [snapshot_child]
Show information about all of the snapshot logical drives or the snapshot logical
drives in the snapshot_child list.
Each snapshot logical drive will output the information shown by the logical
info command.
list [ parent ]
List all snapshot logical drives. If the parent filter is supplied, only snapshot's
parents will be listed.
rollback snapshot_child
Rolls back the snapshots in the snapshot_child list.
Appendix A. Command line interface reference
Levels
all
administrator
administrator
615