Figure 7-61 Save data warning
8. Enter the password and click OK. The default password is config.
Figure 7-62 Change notification
9. Repeat this steps for the second port of the host bus adapter.
7.1.11 Configure the second port of the iSCSI host bus adapter
The second port requires an IP address. This can be done during the POST
BIOS menu of the adapter as it was shown in 7.1.4, "iSCSI host bus adapter
setup and installation preparation" on page 228. SANsurfer provides more
options to configure the host bus adapter than the POST BIOS menu of the host
bus adapter. Two logical drives of the TotalStorage DS300 will be added to the
host COLORADO: one logical drive without authentication and one with.
1. Start SANsurfer and connect to the host.
2. Configure the network address of the second port of the iSCSI host bus
adapter installed in the HS20 blade
265
Chapter 7. TotalStorage DS300 installation