Reset Network And Account Setting To Factory Default; Ibm Serveraid Manager Installation On Microsoft Windows - IBM TotalStorage DS300 Best Practices Manual

interface
manage eth3[B]
ip 192.168.1.126
interface
manage eth3[B]
netmask
255.255.255.192
interface
manage eth3[B]
broadcast
Figure 4-20 Ethernet port ETH3[B] settings
192.168.1.127

4.4.4 Reset network and account setting to factory default

To reset a TotalStorage DS300 or DS400 to factory default state, run the system
defaults command. This command will reset all network settings, feature keys,
and the passwords of the operator and administrator account. It will not delete
arrays, logical drives, initiators or access control lists. These need to be deleted
manually with the ServeRAID Manager console or the command line interface. A
reboot is performed automatically. Connect to the default management IP and
start network setup again.
DS300-1[A]# system defaults
All configured values will be lost!
Restore system to factory defaults? [No]: yes
The system is about to reboot
because it has been reset to the factory default state
DS300-1[A]#
Figure 4-21 Reset factory default
4.5 IBM ServeRAID Manager installation on Microsoft
Windows
To install IBM ServeRAID Manager, any previous installed version of the IBM
ServeRAID Manager should be uninstalled first. For more details about
uninstalling IBM ServeRAID Manager see "IBM ServeRAID Manager removal on
Microsoft Windows" on page 190.
WARNING!!!
Chapter 4. TotalStorage DS300 and DS400 management
91