End Command; Events Commands; Events Inactive Commands - IBM TotalStorage DS300 Best Practices Manual

Hide thumbs Also See for TotalStorage DS300:

Table of Contents

tracert host

Trace the route to a host on the network. You can terminate this command with

A.11 End command

If you are in a context, use this command to leave that context and return to the

previously active context.

Note: This command is not valid from the global context.

A.12 Events commands

These commands control reporting events. You can use these commands after

the events global command with no parameters, or as global commands by

preceding them with events.

Clear the event log.

Display these values associated with the event log:

Size of the event log

List of actions for each level

Current status which means the highest active severity level

A.12.1 Events inactive commands

These commands are used to remove the active state from the selected log

entries. The commands can be executed as global commands by preceding

IBM TotalStorage DS300 and DS400 Best Practices Guide

all | parameters (See Events inactive Commands.)

all | parameters (See Events report commands.)

administrator

Totalstorage ds400