Configure And Run Ibm Serveraid Manager - IBM TotalStorage DS300 Best Practices Manual

3. Install ServeRAID Manager with the rpm -ihv command as shown in
Figure 4-29.
danube:/media/dvd/linux/manager # ls
. .. RaidMan-8.20.i386.rpm
danube:/media/dvd/linux/manager # rpm -ihv RaidMan-8.20.i386.rpm
Preparing...
[100%]
IBM
Version 8.20
1:RaidMan
[100%]
starting IBM ServeRAID Manager agent ...
raid_agent
Installation completed successfully.
The application can be started by running: /usr/RaidMan/RaidMan.sh
danube:/media/dvd/linux/manager #
Figure 4-29 ServeRAID Manager installation using the rpm command

4.7 Configure and run IBM ServeRAID Manager

To be able to manage a DS300/DS400, you need a ServeRAID Manager
Management Station. This Management Station is used to talk via IP to the
network attached storage enclosures. This storage enclosures are called agents.
Note: Only a Microsoft Windows operating system can be used to run the
Management Station.
Only one Management Station can be used to manage a specific TotalStorage
DS300 or DS400. However, multiple Management Stations may be used to
manage different TotalStorage DS300 or DS400 subsystems. In addition,
multiple TotalStorage DS300 or DS400 subsystems can be managed by a single
Management Station. Before an agent can be managed by an other
Management Station, the agent needs to be removed first from its current
Management Station. For information about removing a agent from a
Management Station see "Remove an agent from a Management Station" on
page 104.
###########################################
###########################################
0:off 1:off 2:off 3:on
Chapter 4. TotalStorage DS300 and DS400 management
4:off 5:on 6:off
97