IBM TotalStorage DS300 Best Practices Manual page 593

Press Return (or Enter) twice to require no administrator password.
define operator password
Define whether an operator password is required. (See define administrator
password for instructions on entering this information.)
dhcp
Reply yes or no to determine whether DHCP should be used to discover the
system's network values.
If you enter yes, the wizard takes you to the Save new configuration question
(see save new configuration). If you enter no, the wizard continues with questions
about the system's main ethernet interface.
IP address
Enter the IP number to use in the format described in ip_numb.
Alternatively, the netmask (see netmask) may be defined by entering its width
after the IP number. (See the interface manage commands for more information.)
netmask
Define the size of the netmask. Any of the common formats are accepted, as
described in netmask.
Note: If you entered the netmask as part of the previous IP address, this
question is skipped.
broadcast address
Enter the address to be used for broadcasts. You can use any of the forms
described for the interface manage interface broadcast command.
default gateway
Enter the name or IP number of a router to which packets for destinations that do
not have routes defined for them in the system should be sent. Enter None to
clear the default gateway.
DNS servers
Enter the IP numbers of up to 3 systems that will act as DNS servers. Enter None
to clear the list of DNS servers.
Appendix A. Command line interface reference
575