IBM TotalStorage DS300 Best Practices Manual page 100

DS300-1[A]# interface manage eth2[A] info
----[ Interface 'eth2[A]' ]------------------------------------------------
DS300-1[A]#
Figure 4-6 iSCSI interface information
3. Assign the IP address of the first iSCSI interface. The interface is called
ETH2. A letter A or B in square brackets specifies the controller to which the
interface belongs. Enter the command interface manage eth2[A] ip
192.168.1.61 and press Enter.
Note: Broadcast address and netmask do not fit right now. This will be
changed in the next steps.
DS300-1[A]# interface manage eth2[A] ip 192.168.1.61
Please wait.
Interface values are now:
Broadcast address: 192.168.1.255
DS300-1[A]#
Figure 4-7 Set iSCSI IP interface address
4. Change the subnet mask of the interface ETH2[A] by entering interface
manage eth2[A] netmask 255.255.255.192 and press Enter.
82
IBM TotalStorage DS300 and DS400 Best Practices Guide
Controller: [A] local
Services: iscsi
Status: Enabled
MAC address: 00:00:D1:DE:1B:70
DHCP DISABLED
IP address:
Netmask:
Broadcast:
MTU: 1500
Speed: AUTO
IP address: 192.168.1.61
Netmask: 255.255.255.0