Configure Arrays And Logical Drives On The Totalstorage Ds300 - IBM TotalStorage DS300 Best Practices Manual

logical create ELBE-Quorum ELBE-Quorum 500MB restricted SEINE-HBA0 TIBER-HBA0
logical create ELBE-MSDTC ELBE-Quorum 510MB restricted SEINE-HBA1 TIBER-HBA1
logical create ELBE-Domino ELBE-Domino 10000MB restricted SEINE-HBA0 TIBER-HBA0
logical create ELBE-Exchange ELBE-Exchange 8000MB restricted SEINE-HBA1 TIBER-HBA1
logical create ELBE-DB ELBE-DB 9000MB restricted SEINE-HBA1 TIBER-HBA1
Figure 7-163 Create logical drives
7. Modify the authentication type from none to CHAP for each logical drive.
logical manage ELBE-Quorum authentication CHAP
logical manage ELBE-MSDTC authentication CHAP
logical manage ELBE-Domino authentication CHAP
logical manage ELBE-Exchange authentication CHAP
logical manage ELBE-DB authentication CHAP
Figure 7-164 Modify authentication type
8. Define the username used for the bidirectional authentication. This user name
will be used by the TotalStorage DS300 to authenticate against the initiator.
There is only one account per enclosure. It is not possible to define this
account within the IBM ServeRAID Manager console. Within the iSCSI Server
Adapter or the QLogic iSCSI Expansion Card for IBM BladeCenter BIOS can
be defined only one enclosure account. SANsurfer Pro has the ability to
manage multiple enclosure accounts.
logical chap user ds300-4
Figure 7-165 Create enclosure account
9. Define the enclosure password.
logical chap password
Figure 7-166 Define the enclosure password
The configuration of the TotalStorage DS300 is now compete.
7.5.6 Configure the IBM iSCSI Server Adapter
This section describes the configuration of the iSCSI Server adapter.
1. Start the SANsurfer Pro on the Management station and connect to host
SEINE. When you start the SANsurfer the first time it might be required to
Chapter 7. TotalStorage DS300 installation
333